WATERPOINT Cleaner Water Brighter Tomorrow
Owners

Keeping it running.

The OASIS Home Filter cleans itself rather than being replaced. Three minutes a day and six minutes a week is the whole routine. These are the procedures from the product manual.

Schedule

What to do, and when.

Maintenance schedule
ComponentProcedure and frequency
UF membranesFlush or backwash daily, discarding the water
Multi-media vesselBackwash then rinse, weekly
10 micron bag filterInspect, clean or replace when loaded
Pressure gaugeCheck operating pressure regularly
UF deep cleanTo the membrane manufacturer's recommendation
Daily, about three minutes

Flushing the membranes.

Open the flush valve

Turn the UF backwash valve to put the system into flush mode.

Run for three minutes

Let it run to drain and discard the backwash water.

Return to filter

Set the valve back to the FILTER position and resume normal use.

This lifts accumulated material off the membrane surface. Keep backwash pressure and flow within the membrane manufacturer's limits.

Weekly, about six minutes

Backwashing the vessel.

Backwash for three minutes

Set the valve to BACKWASH, run, and discard the water.

Rinse for three minutes

Set the valve to RINSE, run, and discard that water too.

Back to service

Return the valve to FILTER and resume normal filtration.

The sequence is always backwash, then rinse, then filter. Backwash and rinse discharge should run to a suitable drain.

Watch for

Signs something needs attention.

Flow has dropped
Usually filter loading or membrane fouling. Run the flush and backwash cycles first
Inlet pressure is low
Check supply pressure before assuming the filter is at fault
Water looks or smells off
Stop using it for the affected purpose and email us
Leaks at valves or joints
Close the inlet and email us rather than tightening under pressure
Unit has been idle a while
Flush thoroughly before returning to normal use
About drinking the water

The OASIS Home Filter is built for household non-potable use. It reduces sediment, turbidity, fine particles and microorganisms, but it is not designed to remove dissolved chemical contaminants such as nitrate, fluoride, arsenic, heavy metals or hardness. If you intend to drink the treated water, have it laboratory-tested first and verified as fit for consumption. We can point you to a testing lab.

Support

Something not right?

Email us with your location and what you are seeing. If it needs a visit, we will arrange one.