WATERPOINT Cleaner Water Brighter Tomorrow
Model OHF-01 · Shipping now

OASIS
Home Filter

A household water purification system that mounts on your supply line and treats everything downstream of it. Three stages of filtration, up to 120 litres an hour, running on the pressure you already have.

FILTER UNIT MEDIA VESSEL TO HOUSE SUPPLY
For household use only. Not a drinking water system.

The OASIS Home Filter is designed to treat household supply for washing, bathing, laundry, cleaning and general utility use. It is not designed to remove dissolved chemical contaminants, and it is not sold as a drinking water filter. Before any treated water is used for drinking, it must be laboratory-tested and verified as fit for consumption.

How it works

Three stages, in order.

Water enters from your supply line or existing pump, passes through progressively finer filtration, and returns to the house line.

MAINS SUPPLY TO THE HOUSE 1 Bag pre-filter 10 MICRON 2 Multi-media vessel 8″ × 35″ FRP 3 Ultrafiltration 2 × UF 4040 · ~0.01 µM

10 micron bag filter

Catches sand, silt, rust and the larger suspended particles first, which protects everything downstream from loading up too quickly.

8 by 35 inch multi-media vessel

An FRP vessel packed with a multi-media bed that brings down suspended solids, fine sediment and turbidity. Backwashable, so the bed is cleaned rather than replaced.

Two hollow-fibre UF membranes

A pair of UF 4040 membranes rated to roughly 0.01 micron form the final physical barrier, reducing fine particles, colloidal matter and microorganisms.

What it is for

Every tap in the house.

Bathroom and shower
Reduced sediment and turbidity on skin and hair
Laundry
Less staining and odour carried into fabric
Toilet flushing
Cleaner water through cisterns and fittings
Floors and cleaning
Fewer deposits left behind on surfaces
General utility
Any designated non-potable household use
Running it

Minutes a week.

Daily
Flush the UF membranes for about three minutes and discard the water
Weekly
Backwash the media vessel for three minutes, then rinse for three
As needed
Inspect and clean or replace the bag filter when it loads up
Ongoing
Watch the pressure gauge; a drop in flow usually means it is time to clean

Full procedures are on the support page.

Specification

OHF-01 in full.

OASIS Home Filter technical specification
ModelOHF-01
ApplicationHousehold non-potable water
Filtration typePressure-driven, three stage
Pre-filter10 micron bag filter
Multi-media vessel8" × 35" FRP
UF membrane2 × hollow-fibre UF 4040
UF ratingUp to approximately 0.01 micron
Flow rateUp to 120 litres per hour
Design inlet pressure30 to 40 PSI, with 40 preferred
Dedicated pumpNot required where existing pressure is adequate
Electrical powerNot required for base filtration
Pressure monitoringGauge recommended
MaintenanceDaily UF flush, weekly media backwash and rinse
Manufactured byHydrosun Technologies Pvt. Ltd., Pakistan

Actual filtration performance depends on source water quality, operating pressure, flow, filter condition and membrane integrity. Final operating pressure and flow are confirmed during commissioning.

Installed

What it looks like on the wall.

The cabinet mounts at head height on the supply line, with the media vessel standing below it and the pipework clipped back to the wall.

Visualisation of an OASIS Home Filter installed on the exterior wall of a house, with its blue media vessel below and neat grey pipework
VisualisationGenerated from a photograph of a real installation. Your pipe routing will depend on your own supply and wall.
Next step

We look before we quote.

Installation depends on your supply pressure, your pipe layout and where the vessel can stand. Email us and we will arrange a visit.